Wekiva Parkway Section 6 Design-Build


Wekiva Parkway Section 6 Design-Build RS&H is providing construction engineering and inspection services on the Wekiva Parkway Section 6 Design-Build project for FDOT District Five with project limits from west of SR 429 to just west of Longwood-Markham Road. The project includes six miles of limited access toll road which will be [...]

U.S Route 121 and US Route 460 Connector Phase II


U.S Route 121 and US Route 460 Connector Phase II U.S Route 121 and U.S Route 460 Connector Phase II entails the new construction of approximately 56.25 miles of four-lane limited access highway in southwestern Virginia. These design-build and public-private-partnership projects involve the preliminary engineering, design, and construction of two high-priority corridors [...]

I-96 and I-196 Interchange


I-96 and I-196 Interchange RS&H provided as-needed construction inspection to the Grand Rapids TSC for the initial reconstruction of the I-96 and I-196 Interchange in Grand Rapids. The project includes replacing the westbound I-196 over eastbound I-96 bridge by constructing a new bridge carrying eastbound I-96 over westbound I-196. A new [...]

I-25/Cimarron Street (US 24) Interchange Design-Build


I-25/Cimarron Street (US 24) Interchange Design-Build RS&H served as engineering design lead to Kraemer North America for the I-25/Cimarron (US 24) Interchange, the second largest highway construction project in the Pikes Peak region. The complicated reconstruction, which consisted of converting the interchange to a Single Point Urban Interchange (SPUI), included realignment of [...]

C-470/Santa Fe Flyover Design-Build


C-470/Santa Fe Flyover Design-Build RS&H teamed with Kraemer to provide a new connection between southbound Santa Fe Drive (US 85) and eastbound C-470 in Littleton, Colorado. The flyover bridge spans Santa Fe Drive, C-470, Wolhurst Street, a UPRR bridge, and a BNSF bridge and reaches a maximum height of nearly 70 feet. [...]

Route 29 and Rio Road Grade-Separated Intersection


Route 29 and Rio Road Grade-Separated Intersection RS&H provided Independent Assurance and Independent Verification (IA/IV) services as Owner Representative to VDOT for the US Route 29 Solutions Design-Build project. The US Route 29 Solutions program was made up of three individual design-build projects. The Route 29 and Rio Road Grade-Separated Intersection [...]

Lesner Bridge Replacement


Lesner Bridge Replacement RS&H provided CEI services on the Lesner Bridge Replacement for the City of Virginia Beach. Construction included twin 1,575’ pre-cast, post-tensioned, segmental bridges providing a 45’ clearance over the Lynnhaven Inlet via Shore Drive. Each structure consists of ten spans; nine at 150’ and a channel span of 225’. [...]

North Meadows Extension


North Meadows Extension RS&H served as the prime consultant for the North Meadows extension, a new roadway connection from The Meadows to US 85 and I-25. The project included approximately 2 miles of virgin four-lane arterial roadway; two new interchanges with five bridges at BNSF and UP railroads, Plum Creek, US 85, and [...]

SH 82/Grand Avenue Bridge Replacement


SH 82/Grand Avenue Bridge Replacement RS&H was part of the consultant team that developed and analyzed alternatives for the Grand Avenue Bridge replacement. RS&H provided project management, bridge and structural design, roadway alternatives, hydrology, traffic, environmental assessment, and post-design services. Significant public involvement was used to gain public support for the [...]

Veterans Memorial Bridge


Veterans Memorial Bridge The Veterans Memorial Bridge, funded by the American Recovery and Reinvestment Act, is one of the largest design-build projects the Florida Department of Transportation awarded in 2009. This 3,100-foot, high-level Category 2 bridge structure built within a highly sensitive environmental corridor will provide an important segment in the new connection [...]